Xerox DocuColor 250 Use Manual

Also see for DocuColor 250: Evaluator guide Quick start guide Release note Supplementary guide Quick start guide

Xerox DocuColor 250 Use Manual Manual pdf 1 page image

701P44280September 20051Dear Customer:This document contains directions for printing tabs using the DocuSP controller with the DocuColor 250,2045, 2060, 5252, 6060, 7000, 8000 printers. At the printer:1. Place tabs in appropriate Tray 3 (DocuColor 2045, 2060, 5252) or any tray (DocuColor 250,6060, 8000).• Tabs are short edge feed.• Tabs face the back of the printer.• The last tab of the set must be on top if the job is programmed as N to 1.• Size: 9 X 11 inch.• Weight: program with the correct weight.• If the tabs are precut, be sure to program the tab sequence number, which is the numberof tabs in the set, not the number of tabs used. For example, if the tab set is 5 and only 3tabs are being used, the tab sequence number is 5.Example: Set up a job for seven tabs with the tab information included on the originals:– Tab stock is typically purchased in sets of five tabs. For this job put aside the lastthree tabs of bank two as they are not needed for this job.– Pre-collate the tabs in the tray for every set by reversing the order of the tabs.For this job tab 7 is on top, tab 6 is after that, tab 5 is next, tab 4, tab 3, tab 2, tab1.– Reverse Order would be for N to 1 job finishing, Otherwise 1 to N is ForwardOrder.Note: The tabs cannot just be pulled out of the box and flipped over becausethey will be in the wrong sequence. Extra tabs can be saved for future jobs.– Tabs do not run at rated printer speed because they are heavier stock.– Use Manual job recovery if there is a jam. As jammed tabs are removed, replacethem in the paper tray in the proper order or the whole job will be thrown off.Note: If the jammed tab is the furthest from the paper tray, it will have to be thenext tab fed by the printer.2. Place 8.5 x 11 inch paper in a paper tray short edge feed. Note, the only 8.5x11 stockloaded must be short edge feed. At the DocuSP, access the Printer Manager and follow these steps for setting tabs:1. Select the “Stacking” tab.

/ 2

Related manuals for Xerox DocuColor 250