XciteRC TCPRO ONE10 30306000 User Manual

Contents

XciteRC TCPRO ONE10 30306000 User Manual Manual pdf 19 page image

19TC one10 ProENCharging · Getting started• Insert the supplied BINDING plug into channel 4 of the receiver and then turn the vehicle on. Press andhold the PAIR button on the transmitter and turn it on. The green LED of the transmitter and the receiver‘sLED starts flashing to indicate the binding process. After about 5 seconds, both transmitter LEDs lightup continuously - as well as the LED of the reciever, the transmitter is now bound to the TC one10 Pro.• To activate the failsafe function, set the steering and throttle trim to the center position and remove theBINDING plug. In the event of a transmission failure (eg exceeding the maximum range or empty transmit-ter batteries), the model does not react uncontrollably, just rolls to a halt in a straight line.• If the model cannot be controlled, repeat the process.• WARNING: Never operate your model with inserted BINDING plug! Use it only during the BINDINGprocess - risk of crash!Charging the Battery:Before the first use of your new model the drive battery needs to be charged.ATTENTION: Make sure to read all safety instructions regarding the use of rechargeable batteries.Also, if necessary, further safety instructions in the manual for your used charger.WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-tant adult supervision - fire or explosion hazard!For charging remove the battery from the vehicle.Getting startedInsert the battery into the vehicle and connect the plug to the ESC. Before you start, check all functions ofthe remote control. Does the vehicle follow exactly and directly your commands? Or does it react delayedor choppy? If yes, do not start anyway, but check transmitter and drive batteries and recharge or replace ifnecessary.The run time of your TC one10 Pro depends on your driving style. The maximum run time is reached on astraight and levelled surface. If the battery is weak, the vehicle first gets slower until it finally stops completely.To increase the life time of the drive battery, you should cease operation when the vehicle begins to slowdown.1. Switch on the transmitter, ON/OFF-switch in position I.