OneStart

Menu

XTA MX Series Operator's Manual

Also see for MX Series: Operator's manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Contents
  1. Table Of Contents
  2. DECLARATION OF CONFORMITY
  3. THANKS
  4. IMPORTANT SAFETY INSTRUCTIONS
  5. INSTRUCTIONS DE SECURITE IMPORTANTES
  6. Installing Your MX36: Unpacking
  7. Installing Your MX36: Electrical Considerations
  8. Installing Your MX36: Mechanical Considerations
  9. Connecting To Your MX36: Analogue Line Inputs and Outputs
  10. Operating Your MX36: Initial Set-up and Switching On
  11. Operating Your MX36: The Basics
  12. Outside Your MX36: Front Panel Controls and Indicators
  13. Input / Backup Source Select
  14. Console Select
  15. Line Monitoring
  16. Outside Your MX36: Rear Panel Connections
  17. Inside Your MX36: Configurations and Routing
  18. Operating Your MX36: Working with Failover and Redundancy
  19. Operating Your MX36: With and/or Without Redundancy
  20. Conditions That Trigger a Source Change in Redundancy Mode
  21. Operating Your MX36: Increase Console Capacity with Cascade Mode
  22. Operating Your MX36: Increase Channel Capacity with Parallel Mode
  23. Looking After Your MX36: Maintenance
  24. Performance Of Your MX36: Specifications
  25. Appendix I: Microphone and Stereo Line Input DSP Filter Responses
  26. Appendix II: Upgrading Firmware
  27. Connect To The Unit
  28. Start The Update
XTA MX Series Operator's Manual Manual pdf 12 page image
Page 12 MX Series — MX36 Operating InstructionstaxOperating Your MX36: Initial Set-up and Switching OnPlease read all documentation before operating your unit and retain all documentation forfuture reference.Do not spill water or other liquids into or on the unit and do not operate your unit whilestanding in liquid.Do not ventilation outlets or operate the unit in an environment that could impede the freeflow of air around the unit.If your unit is used in an extremely dusty or smoky environment, it should be cleaned of anycollected debris at regular intervals. Please also see the notes regarding maintenance onpage 28.Switching On…The previous settings of all controls will be recalled, and the audio will fade up after initialboot-up. Note that if the outputs are being fed from a Dante source, this will take longer toreconnect than analogue and AES sources and may start suddenly (after the output fade).A note about the analogue controlsAs these are normal potentiometers and not rotary encoders, their physical positiondetermines their setting. As it’s entirely possible they may have been adjusted when the unitis powered down, be aware that their new position will be used when next powered up, soplease check the gains and headphones level before engaging!
/ 34
This manual is suitable for:
MX SeriesMX36
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved