DPA Series — DPA80/DPA100 Operating Instructions Page 77taxRemote Load 374BBlock 0 of 4096Start The Update!Just before you press the “Load” button — please close any other applications running on thePC — interruptions in the process could render your amplifier inoperable. Do not disconnectthe cable, turn off the power or attempt to close the loader app once loading has begun!Now that you have been warned (!) — press the “Load” button. Confirm the load, and theamplifier will switch to Standby and begin to load the new firmware. A message detailingprogress will accompany the bar on the loader app:Upon completion, the app will close and your amplifier will restart — that’s it!What If It All Goes Wrong…Don’t panic! Your amplifier can be recovered, but please be aware that…THE AMPLIFIER OPERATES AT VOLTAGES IN EXCESS OF THE INCOMING MAINS VOLTAGE,AND THESE VOLTAGES REMAIN PRESENT FOR AN EXTENDED PERIOD AFTER MAINSPOWER IS REMOVED!READ THESE INSTRUCTIONS CAREFULLY AND HEED ALL WARNINGS!Disconnect your amplifier completely from the incoming mains supply.Ensure that the HT present LEDs visible here through the front left vent with the foamremoved……are fully extinguished before continuing. This will take at least five minutes so please bepatient for your own safety.
