XTA 5 series Operator's Manual

Contents

XTA 5 series Operator's Manual Manual pdf 12 page image

Page 12 5 Series5 Series5 Series5 Series Operator’s ManualRear Panel ConnectionsPower Switch: turns the unit’s mains supply off and on.Mains Fuse: located in a finger-proof holder adjacent to the mains inlet. A spare fuseis also located in this holder.Mains Inlet: connected via a standard IEC socket.RS232: RS232 standard via a 9 pin D-type connector, for connection to a PC. Data isconverted to RS485 standard and relayed to slave units via the RS485 sockets.RS485 In-Out: XLR sockets. Used for transmission of remote control data over longdistance or multiple unit applications. See page 33 for more information.For more details on interfaces see our Remote Interface Guide, available on-line.Audio Outputs: 3 pin XLR sockets are provided for each channel. All are fully balanced, pin 2 hot, 3 cold, 1 screen.Note the legending on the panel to designate which outputs are used for AES streams when the digital outputs areenabled. Please see page 36 for more information.AES Input Switch: Recessed switch to select AES digitalinputs. Red LED will illuminate in the hole when AES inputsare selected, along with the corresponding front panelindicator.Audio Inputs: 3 pin XLR sockets are provided for eachchannel. All are fully balanced, pin 2 hot, 3 cold, 1 screen.Note the legending on the panel to designate which inputsare used for AES when the digital inputs are enabled. Pleasesee page 36 for more information.Always replace the fuse with the correct type and rating as shown on the rear panel legend.