OneStart

Menu

XLifter X1 User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Contents
  1. Table Of Contents
  2. Legal disclaimer
  3. Safety information
  4. Installation
  5. EAS Unit Installation
  6. Control Module Installation
  7. Vehicle type and calibration settings
  8. Instruction for use
  9. Function levelling: self-level the vehicle
  10. Menu "Settings": User settings
  11. Calibration
  12. Service menu
  13. Service menu items description
  14. Firmware update
  15. Technical specifications
  16. FAQ & Troubleshooting
  17. Warranty conditions
XLifter X1 User Manual Manual pdf 5 page image
XLifter model X1, user guide, ver. 1.41, firmware ver. 0.98Reco, spol. s.r.o., Na hlinach 6, 18200 Prague, Czech Rep., https//www.xlifter.com, info@xlifter.com Page 44. Installation4.1. Package Contents1x XLifter EAS installation 1x Cable harness with the bypass connector1x XLifter control module 1x Velcro strip for easy control module installation1x User and installation manuals 1x XLifter sticker4.2. Installation - general description and overviewThe XLifter device consists of 2 main components - the control module and the EASinstallation unit (EAS stands for Electronic Air Suspension). The control module (displayunit with buttons) is used to control all settings and to inform the user of the operatingstatus. The EAS unit serves to adjust the wheel height sensor signals and vehicle tiltmeasurements. Communication of the control module and the EAS unit is wireless.The control module is installed anywhere in a suitable place in the interior of the vehicle.The control module needs to be connected to an ignition-switched 12V power supply(cigarette lighter socket). Advanced users may cut the power connector and connect thecable to appropriate 12V junction point. Installation with all cables hidden will look moreaesthetically and the lighter socket will not be blocked.The XLifter EAS unit is installed near the original air suspension control unit and connectswith it via the supplied cable harness. The XLifter EAS unit is mechanically attached to thebody of the vehicle after installation, thus serves also as an accurate tilt sensor.Quick installation overview in 5 steps:1. Install the XLifter EAS unit and connect the cable harness2. Plug the control module power to 12V socket3. Set the appropriate vehicle type (D3, D4, RRS)4. Set the Steering position (left or right-hand side)5. Perform the calibration procedure
/ 24
Related manuals for XLifter X1
XLifter X2 Installation & User Manual first page preview
XLifter X2 Installation & User Manual
This manual is suitable for:
X1
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved