Menu
XLifter X1 User Manual
                        | |
Contents
| 
XLifter model X1, user guide, ver. 1.41, firmware ver. 0.98Reco, spol. s.r.o., Na hlinach 6, 18200 Prague, Czech Rep., https//www.xlifter.com, info@xlifter.com Page 33. Safety informationThis manual contains important information on the installation (in the installation guide) and use ofthe XLifter. Please take some time to read this manual to take full advantage of the XLifter featuresand to ensure that you know how to operate them safely. Use the XLifter only for its intendedpurpose as described in this user manual.What the safety symbols in this user manual mean:This symbol represents potential general warnings, hazards or unsafe practices that mayresult in possible damage to vehicle or vehicle systems. Please read texts marked by thissymbol carefully and proceed according to provided instructions to avoid risks.Warning: This symbol, with the word "warning" attached above or next to the symbol,indicates situations where non-compliance may result in serious injury or damage to theequipment or vehicle.Safety instructions are described on a continuous basis in the description of each XLifter function.However, below is an overview of the most important ones:General warnings:Warning: Ensure that the XLifter is operated only by a person familiar with this manual. Ifanother person is driving, please activate the Keylock function before, as a safety measure.(see chapter 5.4)Warning: If an XLifter is left installed in the vehicle when it is sold, notify the new acquirerand familiarize him with this manual. Please keep this manual permanently in the vehiclein an accessible location for a future reference.Warning: Do not use XLifter while driving on the public roads. Do not lower or raise thevehicle at high speeds.Warnings for the lifter and lifer-free functions:Warning: when in extreme lifts - “Sky Rocket” (+75 mm) or any lift program while the“original” vehicle height is Off Road, please be gentle with the accelerator pedal in case,when you have low-range engaged and you are steering hard to the left or right. Thedriveshafts to CV joints angle is very high. Don’t overstress the CV joints.Warning: In the original “Off Road” vehicle height, it is not recommended to lift the vehiclewith XLifter by more than +25 mm permanently due to possible increase wear of the air-springs.Be gentle to the vehicle compressor! The compressor will overheat when the vehicle islowered/raised several times (3x is usually enough) in a row. When overheated, the LandRover EAS unit inhibit further operation until cooled. Cooling takes about 10 minutes.Warning for the levelling function:Warning: NEVER EVER start the levelling function while driving!!! The wheels height willbe set differently, which results to potentially dangerous situation. Start levelling only whenthe vehicle is stationary!When active, the levelling function must be exited before driving! Otherwise you startdriving with unbalanced wheel heights, exposing yourself to potentially dangeroussituations and you may even damage your vehicle! NEVER leave the camping place withlevelling still active!Do not engage electronic park break (EPB) before or during levelling. It will causeunnecessary tension in park break cables, which will counteract wheel movement. Youmay use the “P” gear instead in the automatic gearbox vehicles.Warning: Close all doors before starting the levelling function to prevent possible damagedue to contact with surrounding ground. |
Related manuals for XLifter X1
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved