X-TREME XB-420M Owner's Manual

Also see for XB-420M: User guide

Contents

X-TREME XB-420M Owner's Manual Manual pdf 15 page image

14ASSEMBLY AND SETUP1) Remove your XB-420M from its shipping carton. TheXB-420M weighs about 150 lbs, so get help, and use care.Cut away any residual packing materials with a knife orscissors. Tools needed for setup are included in the XB-420M tool kit.2) Attach the front wheel:a. Place a support under the floor boardsection to raise the front of the scooter justenough to easily install the front wheel.b. Remove the nut on the axle bolt.c. Slide out the axle bolt and spacer.d. Slide the brake assembly (that is hangingdown) into the wheel cavity.e. Position the wheel between the forks withthe spacer on the side of the wheel thatdoes not contain the brake assembly.f. Slide the axle bolt back in, this time throughthe center of the wheel.g. Tighten the nut on the axle bolt and insertthe cotter (safety) pin.h. Inflate the front and rear tires to 35 psi.3) To make sure the alignment is correct, stand in frontof the vehicle, using both legs to hold the front wheel in astraight-forward position. Use both hands to grab thehandle bar and turn it into normal driving position (90degree angle from the front wheel).4) Attach the Rear View Mirrors to the mounting holes. Awrench can be used to tighten the lock nuts at the baseof each mirror.