X-Rite X-Rite User Manual

Contents

X-Rite X-Rite User Manual Manual pdf 64 page image

X - R i t e e X a c t ™ I n s t r u m e n t625. Tap the Back button to exit the Active Functions selection.6. Tap the Setting button to edit various settings if required. Refer to the Measurement ToolSetup section earlier in this manual for a description of all settings.Sample StorageMake Ready ModeIn make ready mode (Production Mode box unchecked), no measurements are stored as spotchecking or adjustments are being made.Production ModeIn production mode, any measurements made in a Job tool will be stored to the current sheetnumber as a sample that can be uploaded to the iQC Print software for further analysis.Samples are stored with the job until they are deleted from the iQC Print application. Samplesare stored by checking the Production Mode box.Production mode is indicated at the bottom and at the top as a number appearing over theSheet control button in the Navigation bar. All samples measured will be stored to the currentindicated sheet until the sheet is cleared or a new sheet is started.Clear Sheet button: This permanently deletes all samples that may have been stored to thecurrent sheet, and the job mode will operate like no measurements have been made (need tostart with reading the paper patch again).New Sheet button: The sheet number is incremented by one, and any samples that werestored already for the previous sheet are saved. With a new sheet the patches need to beremeasured again starting with paper.Other Job OptionsPatch IconsSelecting this icon accesses the screen where a different patch type can be selected. The lastmeasurement taken for the selected patch will be displayed.Tap the Patch icon to manually switch between different patch types.Note: The icon in this button will change depending on the active patch type.Production mode check boxCurrent sheet numberCurrent sheet number andsample stored