X - R i t e e X a c t ™ I n s t r u m e n t559. Continue with additional measurements or select a measurement screen icon to change coloroption or standard.Pass/Fail MeasurementA pass/fail indication displays for any standard that has a tolerances set. Refer to the softwareapplication for information on setting tolerancing for standards.Pass/fail is displayed differently based on each function and the tolerance types. In general, thearea next to the sample and standard name in the measurement results area will show the overallpass/fail status icon.If the current function displays a delta value which matches an active tolerance, it will also get acolored circle next to it which indicates a particular tolerance passed/warning/failed status.NOTE: Pass/Fail Indication must be activated before a pass/fail measurement can be performed.Refer to Settings in the Measurement Tool Setup section earlier in this manual for procedure.1. Select the tool and function for the pass/fail measurement.2. Measure paper if required.3. Tap the Standard icon to access the screen where a standard is selected from the library.4. Tap the Color Library icon and select the standard from the library.Note: If you want to view the tolerance settings for the selected standard, tap the Toleranceicon .5. Tap the Back icon to return to the measurement screen.6. Measure the sample to be compared.7. View pass/fail results for the measurement.Pass/fail indication
