Whirlpool MK6120XAQ Installation Instruction

STEP 1 STEP 2PART UST CUT-OUT DIMENSIONS/NSTALfdTION /h/STRUCT/Of’tf FOR WHIRLPOOL TRIM-KIT MODELS: MK6120XAQ. MK6120XAB. MK6120XAZ. MK612OXAYFOR USE WITH WHIRLPOOL MICROWAVE OVEN MODELS: MT5120XAQ MT6120X(Q, MT6120XY0. MT6900XW. MT6901XW, KCMSlPPYWH, KCMSIPSYAL. KCMS125YWH, KCMS125YAL. KCMSl25YSB[ UL L&TED - FOR USE OVER GAS 8 ELECTRIC HEAT SOURCE INCLUDING MODELS: RB260PXY, RB220PXY, KEBltO9Y, KEBS107Y 1v Low Profile Screws6 Req’dDuct D4Spring Clips4 Req’dSTEP 31. Disconnect microwave and remove any loose4 items inside the oven before proceeding withinstallation.2. Detach Exiting Strews(4) from the microwavecabinet sides at locations as indicated.3. Install Ducts D4 and DlO by re-attaching ExislingStrews(4) and using No.10 Screws(Z) as shown.4. Position Duct D6 over microwave, coveringrear exhaust vent. Loose/y attach Ductusing No.12 Screws(P) as shown.5. Lift the front of Duct D6 and peel backing offdouble sided tape tram the Duct bottom. Pressdown firmly on Duct. Tighten No.12 Strews(2)at the back.PART NO. 4313745REAR WEW OF MICROWAVE- Duct D6Height = 15 ‘/,’Length = 26 ‘/*.Depth = 23 “/,’ (min.)Microwave OvenCutout OpeningLBuilt-In Ovencutout openhlgSTEP 41. Mark center positions (or center-punch)for the Anti-Tip Bracket as shown.Dlmenslons:A = 4 ‘12’B = 3 ‘Ia’c = 17 ‘I,’2. Drill pilot holes as required.3. Install Anti-Tip Bracketwith Low ProfileStrews(2) as shown.<---_---‘\ ‘\ ‘\‘\ ‘\Cutout FloorLow Profile Screws 7Anti-Tip BracketPage 1

/ 2

Related manuals for Whirlpool MK6120XAB