Whirlpool MALGO27AXX Installation Instructions Manual

GAS DRYER STACKING KIT INSTALLATION INSTRUCTIONS(MAH6700 washer & MDG6700 dryer only)GAS REQUIREMENTSUse only Natural or LP (liquid petroleum) gases.THE INSTALLATION MUST COMFORM WITH LOCAL CODES, OR IN THEABSENCE OF LOCAL CODES, WITH THE NATIONAL FUEL GAS CODEANSI/Z223.1, LATEST REVISION (FOR THE UNITED STATES), OR WITH THECAN/CGA-B149 INSTALLATION CODES (FOR CANADA).A gas dryer is equipped with a burner orifice for operation on NATURAL gas. If thedryer is to be operated on LP gas, it must be converted for safe and properperformance and must be converted by a qualified service technician.Gas conversion kits from LP-to-natural or natural-to-LP are available and are to beinstalled by a qualified service technician.Each dryer will provide an input of 22,000 B.T.U. per hour.A 1/2 inch gas supply line is recommended and must be reduced to connect to the3/8 inch gas line on the dryer.The National Fuel Gas Code requires that an accessible, approved manual gasshut off valve be installed within 6 feet of the dryer.Additionally, a 1/8 inch N.P.T. (National Pipe Thread) plugged tapping, accessiblefor test gauge connection, must be installed immediately upstream of the gassupply connection to the dryer.The dryer must be disconnected from the gas supply piping system during anypressure testing of the system.The Flexing Gas Connector supplied with this kit must be uesd for this installation.In all applications with the dryer stacked on a washer, the Maytag Flexing Gas LineConnector(p/n34001465)must be used.Failure to comply may result in gas line failure or gas leaks.NOTE : Any pipe joint compound used must be resistant to the action of anyliquified petroleum gas.GAS IGNITION- The dryer uses an automatic ignition system to ignite the burner.There is no constant burning pilot.DC68-01052F REV(0.1)Step 1: Place cover (cloth, cardboard, or carpeting) on floorsurface to avoid damage.Step 2: Lay the dryer on its side (not front or back).Step 7: Bottom view of the dryer afterassembling the Stacking Support Guides tothe dryer base.Step 3: Unscrew and disassemble thefour leg assemblies.Step 4: Disassemble each leg from the bracket.Then flip the bracket over and remount onto the leg.Step 5: Reassemble each leg and bracketinto the dryer base.Step 6: Snap the Stacking Support Guides into therectangular holes in the dryer base and secure eachwith two(2) Screws Phillips-pan head(6006-001174).HookCaution : Two people are required to lift the dryer onto the washer.DryerMODEL NO: MALGO27AXX