Whirlpool 1166073 Installation Instructions Manual

Before you start...Proper installation is your responsibility.Make sure you have everythingnecessary for correct installation. It is thecustomer’s responsibility to comply withthe installation specifications provided.Grounded electrical outlet within reachof the power supply cord is required.See Electrical requirements.Electrical Shock HazardIt is the customer’s responsibility:l To contact a qualified electricalinstaller.l To assure that the electricalinstallation is adequate and inconformance with CanadianElectrical Code, Part II or latestedition,* and all local codes andordinances.Failure to do so could result in fire,electrical shock or other personalinjury.utility knifesocket wrench11 .l mm (7/16”) socket &6.4 mm (l/d”) socketThrough-the-wall installations:wood preservative 10, #lO x 25.4 mm (1”) screwsParts supplied forinstallation:window lock 2 side-bracket mountingh a!glessupkrts723 2 verticalsupportsInd-c 6 lock3 f#*xlLrf~m #*x94bmm 11Ox1’9mmc3iw O/4”) 6 flat 6 nutshe:!‘& hex-head, round-head. washersmetal scre\;s metal screws Wood screwsInstallation parts are supplied for doublehung windows up to 101.6 cm (40”) wide.Installation up to 137 cm (54’3 can bemade with a special, wide window kitavailable from your dealer or servicecenter.Panel AElectrical outlet must beavailable within reach ofpower supply cord.Do not use extension cord.F.8 cm(20”)Important: Observe allgoverning codes andordinances.Electrical requirementsElectrical Shock Hazardl Electrical ground is required on thisappliance.l Do Not ground to a gas pipe.l Do Not modify the power supplycord plug. If it does not fit the outlet,have a proper outlet installed by aqualified electrician.l Do Not have a fuse in the neutral orgrounding circuit. A fuse in theneutral or grounding circuit couldresult in electrical shock.l Do Not use an extension cord withthis appliance.l Check with a qualified electrician ifyou are in doubt as to whether theappliance is properly grounded.l Grounding wire must be connectedto grounding screw located in lowerright corner of air conditioner whenair conditioner is in cabinet.Failure to follow these instructionscould result in serious injury or death.LIf codes permit and a separategrounding wire is used, it isrecommended that a qualifiedelectrician determine that thegrounding path is adequate.A single-phase, 60-Hz, AC-only,electrical supply is required on aseparate circuit. A time-delay fuse orcircuit breaker is required - 15amp formodels without electric heater and30-amp for models with electric heater.The fuse size must must not exceed thecircuit rating specified on the modeland serial label. The model and seriallabel is located behind the front panelon the base flange.Personal Injury/Product DamageHazardl Because of the weight and size ofthe air conditioner, more than oneperson is needed to move, lift andsafely install it.l Handle air conditioner with care.Metal fins on front and rear coils aresharp.l Do Not use the water that collectsinside the air conditioner for drinkingpurposes. It is not sanitary.l Maintain a firm hold on the airconditioner to prevent it from fallingout the window during installation.l Do Not locate air condiiioner wherecabinet front is exposed to a healsource that raises the surfacetemperature above 48.9% (12O’F).Failure to follow these instructionscould result in personal injury ordamage to air condiiioner.Specific electrical requirements arelisted in the chart. Follow therequirements for the type of plug on thepower supply cord.Wfrhg requirementsElectrical Shock HazardDisconnect power supply cord fromreceptacle before servicing.Failure to follow these instructionscould result in serious injury or death.Note: Refer to model and serial label forBTUcapacity, amperage, voltage andrefrigerant charge specifications.power supply cordmodels ratedkzt;rdmended groundingFor your personal safety, this appliancemust be grounded. This appliance isequipped with a power supply cordhaving a 3-prong grounding plug. Tominimize possible shock hazard, thecord must be plugged into a mating,3-prong grounding-type wallreceptacle, grounded in accordancewith the Canadian Electrical Code,Part II or latest edition*, and all localcodes and ordinances. If a mating wallreceptacle is not available, it is thepersonal responsibility and obligation ofthe customer to have a properlygrounded, 3-prong wall receptacleinstalled by a qualified electrician.

/ 5

Related manuals for Whirlpool 1166073