Watts ENWARE FHS041 Installation And Maintenance Instructions Manual

Also see for ENWARE FHS041: Installation and maintenance instructions

Watts ENWARE FHS041 Installation And Maintenance Instructions Manual Manual pdf 1 page image

technical dataEnware products are to be installed in accordance with the Plumbing Code of Australia (PCA) and AS/NZS3500.Installations not complying with PCA and AS/NZS 3500 may void the product and performance warranty provisions.Reference should also be made to the Australasian Health Facility Guidelines (AHFG), ABCB and Local Governmentregulations when considering the choice of, and the installation of these products.This product must be installed and commissioned by a qualified plumber.For use with potable water only.NOTE: Enware Australia advises:1. Due to ongoing Research and Development, specifications may change without notice.2. Component specifications may change on some export models.Working Pressure Range Min 50 kPaMax 500 kPaMaximum Static Pressure 1200 kPaMaximum Working Temperature 95°C (Jumper Valve)85°C (Spring loaded valve / Pre-Rinse spray gun)Inlet Connection 1/2” BSPFlow Rate 4 L/min (Pre-rinse spray gun)5 L/min (Pot filler)FHS041FHS141FS015Installation and Maintenance InstructionsHob Mounted Pre-Rinse Unit with Dual MixerAssemblyI00543_22 Feb 20241300 369 273 | info@enware.com.au | enware.com.au