WAGNER ProSpray 23 Operating Manual

WAGNER ProSpray 23 Operating Manual Manual pdf 51 page image

ProSpray 23 49g AppendixBore Spray width at about 30 cm Flat jetTip marking mm removal of spray object Use adjusting tipPressure 100 bar (10 MPa) Order no.15 0.13 - 0.46 5 - 35 cm Paints 0999 05720 0.18 - 0.48 5 - 50 cm Paints, fillers 0999 05328 0.28 - 0.66 8 - 55 cm Paints, dispersions 0999 05441 0.43 - 0.88 10 - 60 cm Rust protectionpaints - dispersions 0999 05549 0.53 - 1.37 10 - 40 cm Large-area coats 0999 056Contact protectionfor the flat jet adjustment tipOrder no. 0097 294Tip extension withslewable knee joint(without tip)Length 100 cm Order no. 0096 015Length 200 cm Order no. 0096 016Length 300 cm Order no. 0096 017Tip extensionLength 15 cm Order no. 0999 320Length 30 cm Order no. 0999 321Length 45 cm Order no. 0999 322Length 60 cm Order no. 0999 32313. Appendix13.1 Selection of tipTo achieve faultless and rational working, the selection of the tip is of the greatest importance.In many cases the correct tip can only be determined by means of a spraying test.Some rules for this:The spray jet must be even.If streaks appear in the spray jet the spraying pressure is either too low or the viscosity of the coating material to high.Remedy: Increase pressure or dilute coating material. Each pump conveys a certain quantity in proportion to the sizeof the tip:The following principle is valid: large tip = low pressuresmall tip = high pressureThere is a large range of tips with various spraying angles.13.2 Servicing and cleaning of Airless hard-metal tipsStandard tipsIf a different tip type has been fitted, then clean it according to manufacturer’s instructions.The tip has a bore processed with the greatest precision. Careful handling is necessary to achieve long durability.Do not forget the fact that the hard-metal insert is brittle! Never throw the tip or handle with sharp metal objects.The following points must be observed to keep the tip clean and ready for use:1. Open the relief valve, valve position PRIME ( k circulation).2. Switch off unit.3. Dismount the tip from the spray gun.4. Place tip in an appropriate cleaning agent until all coating material residue is dissolved.5. If there is pressure air, blow out tip.6. Remove any residue by means of a sharp wooden rod (toothpick).7. Check the tip with the help of a magnifying glass and, if necessary, repeat points 4 to 6.13.3 Spray gun accessoriesFlat jet adjusting tipup to 250 bar (25 MPa)