Varytec Easy Move XS HP Wash User Manual

Also see for Easy Move XS HP Wash: User manual User manual

Contents

Varytec Easy Move XS HP Wash User Manual Manual pdf 7 page image

7 / 14Disconnect the power cord before replacing a fuse and always replace with the same type fuse.4. Set upPower Supply: Before plugging your unit in, be sure the source voltage in your area matches therequired voltage. The Light is available in a 110v to 250v version. Because line voltage may vary fromvenue to venue, you should be sure your unit voltage matches the wall outlet voltage beforeattempting to operate you fixture.4.1. Fuse replacementWith a flat head screwdriver wedge the fuse hold out of its housing. Remove the damaged fuse fromits holder and replace with exact same type fuse. Insert the fuse holder back in its place and reconnectpower.4.2. Fixture linkingYou will need a serial data link to run light show of one or more fixtures using a DMX-512 controller orto run synchronized on two or more fixtures set to a master/slave operating mode. The combinednumber of channels required by all the fixtures on a serial data link determines the number of fixturesthe data link can support.Maximum recommended serial data link distance: 500 meters (1640ft).Maximum recommended number of fixtures on a serial data link: 32 fixtures.Data cablingTo link fixtures together you must obtain data cables. If you choose to create your own cable pleaseuse data-grade cables that can carry a high quality signal and are less prone to electromagneticinterference.4.3. 3-Pin to 5-Pin conversion chartNote! If you use a controller with a 5 pin DMX output connector. you will need to use a 5pin to 3 pinCHAUVET Model No: DMX 5M or DMX 5FThe chart below details a proper cable conversion: