10 / 146.3. Slave ModeUp-to 32 units can be daisy chained together with one single unit acting as Master and all other linkedunits as Slaves. Slave units will all run in synch with the master unit without the need for an additionalcontroller. Connections can be made using standard DMX control cables with Master unit running inAuto Run or Sound Activated Modes an placed at the start of the chainChoosing Slave ModeTo select, use the “MODE/ESC” button and choose “SLAu”. When the “ENTER” button is pressed theLED display changes to “Son” and the unit will be slaved to control signals coming from a Master unit6.4. Service ModesAfter major configuration changes it may be necessary to reboot or reset the unit.Resetting the UnitTo select, use the “MODE/ESC” button and choose “rEST”(restore). Press “ENTER” to confirm. Theunit powers itself down and then on again for a few seconds. During this time the LED display willscroll “rEST” from left to right, after which normal operation recommences.Restoring factory defaultsTo select, use the “MODE/ESC” button and choose “LoAD”(load). Press “ENTER” to confirm. The LEDdisplay will change to “d001” to confirm a factory reset has been completedPowering the unit initiallyDuring the warm up the unit will auto test itself for a few seconds. During this time the leddisplay will scroll “rEST” from left to right .The unit then commences operation normall6.5. DMX ModesThe unit supports 5 and 12 channel DMX Sub-modes frim a standard desk. When a suitable DMXconnection is made, the “decimal point” in “d.001” will flash.Setting DMX AddressesUse the “MODE/ESC” button to display “d001”, “UP” and “DOWN” buttons allows individual DMXaddresses to be set from “d001” to “d512”Choosing between DMX Sub-modesThe LED display shows the chosen control mode when the “MODE” button is pressed. Use “UP” and“DOWN” buttons to choose the appropriated DMX control ModeLED Display DMX Sub-mode5CH 5Channel12CH 12channel