Vari Lite VL3500 SERIES User Manual

Vari Lite VL3500 SERIES User Manual Manual pdf 32 page image

VARI❋LITE® - VL3500™ SERIES LUMINAIRE USER’S MANUAL16 31-July-2004 0 2.9678 .0019 0AddressingProgram Starting AddressThe address setting for DMX console controlled systems is entered using the Menu Display (refer o“Menu Operation” on page 46). The luminaire retains the DMX address even if power is removed.Note: Refer to your console operating instructions for specific information regarding s addressingrequirements.Program a DMX starting address:Step 1. Press [Menu].Step 2. Press [Up] / [Down] arrows until Address appears. Press [En er].Step 3. Press [Up] / [Down] arrows to enter starting addressStep 4. Press [Enter] to set.Program Starting Address Without CalibratingLuminaireIt is possible to bypass the calibration seq ence and go directly to the Menu Display programming inorder to pre-program an address setting.Program starting address without calibrating luminaire:• While powering up luminai press and hold [Menu]. Program address as in Program StartingAddress above.• Press and hold [Menu] until display changes from "Starting" to the DMX address.Note: The lumina re will require a reset to restore control.www.carlosmendoza.com.mx