Vari Lite VL2416 User Manual

Also see for VL2416: User manual User manual

Contents

Vari Lite VL2416 User Manual Manual pdf 41 page image

INSTALLATION : A DDRESSING202.9 661.00 01J 22-Feb-02 23AddressingProgram Starting AddressThe address setting for DMX console or Virtuoso console controlled systems isentered using the Menu Display. (Refer to “Menu System” chapter on page 45 fordetailed instructions.)The luminaire retains the DMX and Virtuoso addresses that are stored even if power isremoved.Note: Refer to your console operating instructions for specific information regardingits addressing requirements.Program a DMX or Virtuoso starting address:Step 1. Press [Menu].Step 2. Press [Up] / [Down] arrows until ADDR (Address) appears. Press [Enter].Step 3. Press [Up] / [Down] arrows to access DMX (DMX console control) or VIRT(Virtuoso console control). Press [Enter].Step 4. Press [Up] / [Down] arrows to enter starting address.Step 5. Press [Enter] to set.Program Starting Address Without Calibratingthe LuminaireIt is possible to bypass the calibration sequence and go directly to the Menu Displayprogramming in order to pre-program an address setting.Program starting address without calibrating luminaire:• While powering up luminaire, press and hold [Menu]. Program address as inProgram Starting Address above.Note: The luminaire will require a reset to restore control.