VARI❋LITE® - VL2000™ SPOT LUMINAIRE U SER’S MANUAL86 02-May-03 02 .9 673 .00 01 DNote: In some cases it is easier to slide bulkhead partially out of head assembly to access color filters.To do this, use #2 Phillips screwdriver to turn captive screw one-quarter turn and slide bulkheadupward. Disconnect motor connections as necessary.Step 3. Rotate wheel until required color filter is accessible at finger access cutout.Figure A-3: Filter AccessCAUTION: Do not touch color filters with bare fingers. Wear cotton gloves or other covering whilereplacing. Clean with glass cleaner and soft cloth if touched.Step 4. Using fingers, pull color filter out of wheel.Step 5. Noting proper orientation of carrier slot, insertnew color filter into position and push fully intoplace.Step 6. Re-install bulkhead (if applicable) and re-installremovable cover.Figure A-4: Color Filter RemovalFinger AccessCutoutColor FilterColorFilter WheelColor FilterCarrier Slotwww.carlosmendoza.com.mx
