Vanguard UNVENTED (VENT-FREE) PROPANE/LP GAS LOG HEATER Operation And Installation Manual

Also see for FLAME-MAX VYD36PR: OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Vanguard UNVENTED (VENT-FREE) PROPANE/LP GAS LOG HEATER Operation And Installation Manual Manual pdf 14 page image

14105274UNVENTED PROPANE/LP GAS LOG HEATERVANGUARD FLAME-MAX®INSTALLATIONContinuedWARNING: Failure to positionthe parts in accordance with thesediagrams or failure to use onlyparts specifically approved withthis heater may result in propertydamage or personal injury.INSTALLING LOGSIt is very important to install the logs exactlyas instructed. Do not modify logs. Only uselogs supplied with heater.1. Place one-piece log set on grate to fitas illustrated in Figure 17. Make suremiddle section at bottom of log set isseated into “U”-shaped cutout in cen-ter of chassis (see Figure 17).Note: 36”model has more features but fits on thechassis the same. Log will fit securelyon chassis.IMPORTANT: Make surelog does not cover any burner ports.2. Place lava rock around base of heater.Figure 17 - Installing Golden Oak One-Piece Log SetFigure 18 - Installing Golden Oak One-Piece Log set (Top View)CAUTION: After installationand periodically thereafter, checkto ensure that no flame comes incontact with any log. With theheater set to High, check to see ifflames contact any log. If so, re-position logs according to thelog installation instructions in thismanual. Flames contacting logswill create soot.One Piece Log SetBurnerMiddleSection atBottom ofLog Set"U"-shaped Cutoutin ChassisChassisOne Piece Log SetBurnerPorts