Val Controls IHP24-A Hardware Manual

Also see for IHP24-A: Hardware manual User manual Manual

Contents

Val Controls IHP24-A Hardware Manual Manual pdf 3 page image

DHW-UM-002Val Controls A/S • Limfjordsvej 3 • DK-6715 Esbjerg N • Tel. +45 7547 0600vc@valcontrols.com • www.valcontrols.comRevision: 33/201 GeneralThis manual covers the following products:IHP24-AIDP24-A with software DID-SW-001IVC24-AIDC24-AILB24-AILC24-AIPC24-A1.1 Safety instructionsFor a safe installation of a Val Controls device, the following must be observed. The module mustbe installed by qualified personnel who are familiar with the national and international laws,directives and standards that apply to this product as well as all instructions in this manual.The information in this manual is subject to changes without notice.1.2 EnvironmentOperating temperature: -30 to 80 ˚CStorage temperature: -30 to 80 ˚CExtended operating temperature1: -40 to 85˚CExtended storage temperature1: -55 to 100˚C1 Please contact Val ControlsRelative Humidity: < 95% (No condensation)The printed circuit boards are coated for tropical climate and harsh environments to resist airbornecontamination according to G3, ISA-71.04-2013.Ingress protection: IP201.3 Mounting and dimensionMounting: 35mm DIN rail according to EN50022.Screw torque: 0.4Nm (3.6Lb. in)Wire diameter: 28-12 AWG 2.5mm2All external components must have specifications that fit the desired performance and requirementsof the valve/actuator system.Dimensional drawing can be found on www.valcontrols.com