Unitech MS840B User Manual

Also see for MS084: User manual User manual User manual

Unitech MS840B User Manual Manual pdf 32 page image

20Barcode Length SettingThe following example illustrates how to set Code 39 with a minimum length of 5and a maximum length of* Scan “Enter Group 7”.Scan “F1” to select Code 39.Scan “MIN LENGTH” to enter minimum length setting.um length setting.20.*** Scan “0” and “5” to select length 5.* Scan “MIN LENGTH” to end minimum length setting.* Scan “MAX LENGTH” to enter maximum length setting.* Scan “2” and “0” to select length 20.* Scan “MAX LENGTH” to end maxim* Scan “Exit” to end setup.Code ID SettingEach barcode symbology supported by the sow what the label that you’re scanning is, you maycanner has a default ID characterdefined below. If you don’t kn.use this feature to identifySymbology Pre-DefinedUPC-A AUPC-E EEAN-13 FEAN-8 FFI 2 of 5 IS 2 of 5 HCode 39 MCodabar NCode 93 LCode 128 KUCC/EAN128 ]C1MSI OCode 32 TDelta Code DPlessey Code PLabel Code IV,V BChina Postal Code CThose ID characters can be redefined through setup menu. The following exampleshows how to set Code 93 with ID ‘O’ and Code 128 without ID:* Scan “Enter Group 5”.* Scan “D2” to select Code ID.* Scan “1” for "Enable".* Scan “D3” to define IDs.* Scan “0” and “9” for selecting Code 93.* Scan “O” from Full ASCII Table for new ID.* Scan “0” and "8" to select Code 128.