Unitech MS840B User Manual

Also see for MS084: User manual User manual User manual

Unitech MS840B User Manual Manual pdf 31 page image

19e confi application. Alle hich is retainedChapter 3Barcode SettingThe scanner interface can b gured to fit the user's specificconfiguration parameters are stor d in a non-volatile memory, weven if power is lost.Barcode Menu SettingThe setup menu in Appendix D contains eight groups:elay.* Group and Emulation.232 Settingscanner port.netic Readere 39, I 2 of 5, S 2 of 5 and Code 32.* Group 8: Code 128, Code 93, Code 11, Codabar, and MSI.* Group 9: UPC/EAN, and Delta Distance Code.* Group 10: Data Editing.* Group 11: Dump setup.Setup ProceduresFor most parameters, proceed the following steps for the setting:1. Locate a group that contains the parameter to be changed.2. Scan the "Enter Group #" label to enter setup mode. The green LED on thescanner will flash to indicate that setup is in progress.3. Scan the label (on right hand side) representing the parameter to be changed,such as B1 label.4. Scan the labels (number) representing the desired parameter value; forexample, for 05, scan “0” and “5” labels.5. Repeat steps 3 and 4, if necessary, to change the parameters in the samegroup.6. Scan "Exit" label to end the group setup. The scanner will make two beeps toend the setup.* Group 1: Device selection.* Group 2: Beep and d3: Keyboard and W* Group 4: RS-* Group 5: S* Group 6: Mag* Group 7: Cod