4. For greater use of the printer30Printing can be automatically produced by sending a print command from the SI/F or RS-232Cinterface to the M252A. Select whether this Automatic Print is ON or OFF.Details of settingsON........................... Printing is produced when a print command is sent from the SI/F or RS-232C interface. For the print commands from the SI/F and RS-232C inter-face, see the instruction manual of each indicator and "RS-232Cinterface(option)"(page 49).OFF......................... Printing is not produced with a print command from the SI/F or RS-232Cinterface.■ For the print command from the SI/F, see the instruction manual of each connection indicator.■ For the print command from the RS-232C interface, see "RS-232C interface(option)"(page 49).Select whether or not to print at fixed intervals.Name of setting 08: Automatic Print ON/OFFSelection item 0. OFF1. ON (initial value)Caution ・Printing is always produced in the following conditions irrespective ofwhether Automatic Print is ON or OFF.・When the [PRINT] key is pressed.・When the PRINT terminal and COM terminal to the rear panel areshort-circuited.・Since an automatic print command cannot be given from the BCDinput, it is necessary to give a print command on the printer forprinting print data from the BCD input.Name of setting 09: Interval Print ON/OFFSelection item 0. OFF (initial value)1. ONCaution Keys other than [STOP] (to stop Interval Print) and [ENT]cannot be used during Interval Print.08: Automatic Print ON/OFF09: Interval Print ON/OFF
