Convert Server User Manual www.usriot.comJinan USR IOT Technology Limited 28 / 44 tec@usr.cnFigure 19 Quick Configure PageThis page has four configuration options and a restart, the corresponding instructions below: WI-FI Setting: set the working mode of wifi, AP mode or the STA. Ethernet Ports Setting: open/close the Ethernet ports, and set up the corresponding work mode. UART Setting: set serial port parameters, including baud rate, parity bit, 485 functions and so on. Network Setting: set network parameters, Only TCPA related parameters. Device Management: when after completion of the above parameters are configured, click reset ConvertServer.6.1.3. Mode Selection PageThis page use to setting the wireless networking mode (AP and STA mode)."Data transmission mode" selection Convert Server working mode are "Transparent Mode", "Serial Commandmode", "GPIO mode"and””HTTPD-Client Mode”.
