3Proper InstallationThis water filtering system must be properly installed and located in accordance with theInstallation Instructions before it is used or the warranty will be void. Do not install or store where the systemwill be exposed to temperatures belowfreezing or exposed to any type of weather.Water freezing in the system will break it.Do not attempt to treat water over 100°F. Do not install in direct sunlight. Exces-sive sun or heat may cause distortion orother damage to non-metallic parts. Properly ground to conform with all govern-ing codes and ordinances. Use only lead-free solder and flux for allsweat-solder connections, as required bystate and federal codes. Maximum allowable inlet water pressure is80 psi. If daytime pressure is over 60 psi,night time pressure may exceed the maxi-mum. Use a pressure reducing valve to re-duce the pressure. WARNING: Discard all unused parts andpackaging material after installation. Smallparts remaining after the installation couldbe a choke hazard.The Aquatrol system provides Chlorine and Chloramine removal throughout the home. TheAquatrol system should be installed at the point of entry to treat the entire home, both hot andcold water.The Catalytic Carbon media in the Aquatrol system tank provides filtration when the system isin service to collect contaminants. These contaminants are backwashed from the mediasurface when the system regenerates/backwashes.Aquatrol Oxi-Gen Benefits Chlorine and Chloramine Removal Virtually maintenance free. Improves the efficiency of water-using appliances Simple installation Safe for landscaping and lawn watering. Compatible with all on-site and community wastewater treatment systemsIntroductionInstallation, Operation and Maintenance ManualAQF-CX-100 & AQF-CX-200