Menu
ULTRAFRYER PD14 Operation Instructions Manual
                                              | |
Contents
| 
3330A215-Mar2008E. SHORTENING INSTALLATION1. LIQUID SHORTENING: When using liquid shortening (cooking oil), fill the fryer with shortening even with themiddle line of the “E” in the word LEVEL of the shortening level mark on the rear wall of the fryer.2. SOLID SHORTENING:a) Cut a block of solid shortening into small pieces.b) Place small pieces of solid shortening EVENLY on top of the HEAT EXCHANGER TUBES or THOROUGHLYPACK these pieces of solid shortening between, below, and above the HEAT EXCHANGER TUBES. Whilepacking solid shortening is messy and time-consuming, it is the fastest and safest way to melt solid shortening.c) Ultrastat 25 equipped Fryer:1) Place the computer in the SHORTENING MELT MODE by pressing the ON/OFF key. MELT G/Pwill appear in the computer display to indicate the computer is in the SHORTENING MELT MODE; andthe HEAT DEMANDS lamp on the computer and RED Heating indicator lamp on the fryer will cycle ONand OFF, indicating the burner is periodically being turned ON and OFF to heat the shortening gradually.2) When the heat exchanger tubes are COMPLETELY covered with LIQUID shortening and the shortening isABOVE the MELT RELEASE TEMPERATURE, replace the grill in the fryer vat; then push the OK/EXITkey on the computer.d) Continue adding solid shortening as follows:1) Place small pieces of solid shortening into a fry basket.2) CAREFULLY lower the basket into the fryer vat.3) GENTLY turn the basket to allow these pieces of solid shortening to float away.4) Repeat the above steps until liquid shortening is even with the middle line of the “E” in the wordLEVEL of the shortening level mark on the rear wall of the fryer vat.WARNING!!! TO AVOID INJURYI DO NOT MOVE A FRYER FILLED WITH HOT LIQUID.II DO NOT GO NEAR THE AREA DIRECTLY OVER THE FLUE OUTLET WHEN THE FRYER’S MAINBURNERS ARE OPERATING.III ALWAYS WEAR OIL-PROOF, INSULATED GLOVES WHEN WORKING WITH A FRYER FILLED WITHHOT OIL.IV ALWAYS DRAIN HOT OIL INTO A METAL TUB, POT OR CAN ... HOT OIL CAN MELT PLASTICPDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor |
Related manuals for ULTRAFRYER PD14
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved