Menu
UBCO 2x2 Dual-Use 2018 User Manual
                                                         | |
Contents
| 
SPACER INSERTM8 x 25mmCOUNTERSUNKREAR TORQUE ARMREAR TORQUE ARM M14 SERATEDFLANGE NUTM6 X 16mmWASHERM8 NYLOC NUTM8 FLANGE NUT49Removing the Rear Wheel:a. Unscrew the motor cable locking sleeves anddetach the two motor cable ends.b. Using a 6mm Allen Key unscrew and removethe two M8 countersunk cap screws on thetorque arms.c. With a No. 21 spanner, loosen the two serratedflange nuts. (TOOL TIP: it is easiest to removethe nuts from the axle).d. Remove the left and right torque arms from therecesses in the swing arm. The wheel is nowfree to be removed.e. When putting the wheel back on ensurethat the nuts are tightened to 80 Nm witha torque wrench.Swapping Front and Rear WheelsThe front and rear wheels each have spacer insertswhich are installed on the axles. These inserts arespecific for installation in the front fork and rearswing arm. If you wish to swap the wheels aroundfor whatever reason, be sure to swap these insertsand torque arms before installing into the 2×2.Directional indicators, reflectors, rear light, number plate holder and mirrors on the road version only. |
Related manuals for UBCO 2x2 Dual-Use 2018
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved