U-Line WINE CAPTAIN 1115R Use And Care Manual

Also see for 1115R: Install guide Use and care guide Install guide Use and care guide Specifications

Contents

U-Line WINE CAPTAIN 1115R Use And Care Manual Manual pdf 17 page image

U-Line Standrd Door Alignment and Reversal 157 Standard DoorsDoor Alignment and AdjustmentAlign and adjust the door if it is not level, or is not sealing properly.If the door is not sealed the unit may not cool properly, orexcessive frost may form in the interior.IMPORTANTIMPORTANTProperly aligned, the door’s gasket should be firmly incontact with the cabinet all the way around the door (nogaps). Carefully examine the door’s gasket to assure thatit is firmly in contact with the cabinet. Also make sure thedoor gasket is not pinched on the hinge side of the door.To align and adjust the door:1. Loosen (do not remove) top and bottom hinge screws.2. Align door squarely with cabinet.3. Make sure gasket is firmly in contact with cabinet all the wayaround the door (no gaps).4. Tighten bottom hinge screws.5. Tighten top hinge screws.Door ReversabilityLocation of the unit may make it desirable to mount the door onthe opposite side of the cabinet.Models with black and white doors are field-reversible.Stainless steel models with glass doors without locks are field-reversible.Stainless steel models without glass doors must be ordered right-or left-hand hinged.Reversing the doorThe Hinge hardware will be removed and reinstalled on theopposite side of the cabinet.The hinge plate is flipped over when it is reinstalled on theopposite side of the cabinet.To reverse the door:Remove grille:Remove the grille see MAINTENANCE section of this guide.Remove top hinge, and door:1. Hold door to keep it from falling.2. Remove top hinge from cabinet by removing three or fourscrews, depending on model.3. Remove door by tilting forward and lifting door off bottomhinge.4. Remove three or four plastic screw plugs from hinge holes onthe opposite side. Reinstall into holes where the hinge wasremoved. Ensure not to scratch cabinet.Remove bottom hinge:1. Remove bottom hinge from cabinet. Some models will have agusset with two screws. Other models will have a plate withthree screws.2. Remove corresponding screws on opposite side of cabinet. OnPlasticPlug HolePlasticPlug HoleRight SideDoor Swing Left SideDoor Swing