U-Line WINE CAPTAIN 1115R Use And Care Manual

Also see for 1115R: Install guide Use and care guide Install guide Use and care guide Specifications

Contents

U-Line WINE CAPTAIN 1115R Use And Care Manual Manual pdf 18 page image

16 U-Line Standard Door Alignment and ReversalInstall bottom hinge:1. If you have a plate hinge, reorient the pivot screw so itprotrudes the opposite direction form the hinge. Remove thepivot screw from the hinge. Turn the plate over and reinstallthe screw.2. Align hinge outer edge with cabinet. For models with a platehinge, the flat edge of the hinge alignes with the outer edge ofthe cabinet.Install two or three screws, depending on model. Replace nuts ifused.Prepare door for reinstallation:For stainless steel models with glass doors:3. Stainless glass doors are flipped upside down to be reversed.4. Lay the door on it’s side. Remove the plastic hole plug (1) andinstall in the corner opposite of where it was removed.5. Remove the plastic hinge bushing (2) and install in the corneropposite of where it was removed.6. Remove the U-Line nameplate (3) from door. This will revealmounting holes for the door actuator bracket.7. Remove door actuator (4) from door. Be sure to only removethe two screws holding the actuator to the door. Reinstall theactuator (4) on the opposite end of the door where thenameplate was removed.8. Install new nameplate where the actuator assembly wasremoved.9. Install screws into holes on opposite side, where the hinge wasremoved. Replace nuts if used.11234Prepare door for reinstallation:For black or white doors:1. Remove plastic hole plug from top of door handle and reinstallon opposite side.2. Remove plastic hinge bushing on bottom of door and reinstall onopposite side. Clean out bushing hole in door bottom with ascrewdriver if necessary.Install top hinge, and door:1. Reorient the pivot screw so it protrudes the oppositedirection from the hinge. Remove the pivot screw from thehinge. Turn the plate over and reinstall the screw.2. Hold door to keep it from falling.3. Lift the door on to the bottom hinge.4. Align flat edge of the hinge with the outer edge of the unit.5. Install three or four screws, depending on model.Align and adjust the door:1. Align and adjust the door, see DOOR ALIGNMENT ANDADJUSTMENT above.Install grille:Install the grille, see MAINTENANCE section of this guide.