U-Line U-3018CLROL-00 Install Manual

Also see for 3018CLRS00: Use and care guide

Contents

U-Line U-3018CLROL-00 Install Manual Manual pdf 14 page image

Installation Guide 12Ice MachinesThe unit requires a 1/4" O.D. soft copper supply line, or flexiblewater supply kit from U-Line (Part No. WATERHOOKUP).WARNING!Prior to attempting installation, determine if this productcontains a gravity style drain or factory installed drainpump. Products without a drain pump may only use agravity style drain. Failure to connect water supply ordrain line connections properly may result in waterleakage, personal injury, and/or property damage.Disconnect power and turn off water to the unit beforeattempting to alter these connections. Please consultU-Line or your installation instructions for further details.These connections are the responsibility of the owner andmust be connected per local plumbing code. If you areuncertain of how to safely and properly install thisproduct, contact a licensed plumber.Water Connections:CAUTION!Review, obey, and understand the local plumbing codesbefore you install your unit. Connect to the cold watersupply. The water pressure should be between 20 and120 psi. The water line MUST have a shut-off valve on the1/4" supply line.CAUTION!• U-Line requires the use of copper tubing for installation orthe U-Line water hookup kit available at www.u-line.com.This kit includes a flexible water supply connecting hoseand brass fitting.• Do not use any plastic water supply line. The line is underpressure at all times. Plastic may crack or rupture withage and cause damage to your home.• Do not use Teflon tape or joint compound on the waterfitting. The rubber washer provides an adequate seal.Other materials could cause blockage of the valve.• Failure to follow recommendations and instructions mayresult in damage and/or harm, flooding or void theproduct warranty.1/4” Copper Water Supply ConnectionCAUTION!Turn off water supply and disconnect electrical supply tounit prior to attempting installation.1. Turn off water supply and disconnect electrical supply to productprior to attempting installation.2. Remove back panel of unit.3. Remove front panel of unit. See image below for location of frontpanel screws.4. Locate the desired cold water supply location.5. Attach a 1/4" copper line to thislocation and route the tubing to theappliance. Leave approximately 8' ofwater line to be coiled behind theappliance. The water line should belooped into 2 coils. This will allowthe line to flex when removing theunit for cleaning and service. Do notkink or pinch the coiled line.6. Take the end of the copper tubingand put the line through the hole in the back panel.7. Then take the end of the copper tubing and feed it through theopening between the condenser and the side of the unit. Thecopper tubing should be within two inches of the top of thecompartment.8. Locate the U-Line supplied hose fitting. Ensure the end on thecopper tubing has been cut straight and is free of burrs. Slide the10 Prepare PlumbingFront PanelRemove screws(one on each side)to access behindthe front panelWater inlet lineshould be within 2inches of the top ofthe compartment