SS1095 13MARINE SERIES13. Remove all three screws on the opposite side of thehinge and carefully lift off the door latch assembly(Figure 23).Figure 2314. Place the door latch assembly on opposite side of unit.Be sure to tighten all three screws securely (Figure 24).15. Place door on lower hinge pin. Invert and install upperhinge on door. Fasten upper hinge to unit (threescrews) (Figure 24). Partially tighten screws..Figure 2416. Adjust door to assure proper seal. Tighten upper andlower hinge screws securely.17. Replace screws in holes in bottom of unit on oppositeside.18. Replace the grille.Before Calling for ServiceIf your U-Line product appears to be malfunctioning, readthrough the OPERATION section of this guide to ensurethat the function of all controls are clearly understood. Ifthe malfunction persists, the TROUBLESHOOTING GUIDEin this guide will assist you in quickly identifying commonproblems, and provide information on possible causes andremedies. Most often, this will resolve the problemwithout the need to call for service.If Service is RequiredIf you do not understand a troubleshooting remedy, oryour product needs service, contact U-Line Corporationdirectly. Contact information appears on the rear cover ofthis guide.You will be asked for your product Model and SerialNumbers. This information should be recorded inside thefront cover of this guide, following the products originalpurchase. It also appears on the Model and Serial numberplate located on the upper right or rear wall of theinterior of your product.Replacement PartsWhen you need replacement parts, always request thatgenuine U-Line replacements be used. U-Line productshave been designed and engineered using componentsthat work efficiently, and provide superior service life andperformance. The use of aftermarket parts or componentsmay affect the safety, operation, performance ordurability of your product, and may also void its warranty.ULIN_0145_A7 Service