CLR2160, CLRCO2175 5Drain ConnectionIMPORTANTIMPORTANTDrain can NOT be located directly below unit. Unithas a solid base that will not allow unit to drainbelow itself.The CLR2160 or CLRCO2175 can be installed using aGravity Drain, a Factory-Installed Drain Pump (U-Line P60)or a Locally-Installed (U-Line P60) Drain Pump. Drain linesmust have a 5/8” inside diameter. The floor drain must belarge enough to accommodate drainage from all attacheddrains.Note: We strongly recommend the use of the U-LineCLRDRAINKIT for both gravity & pump installations.Depending on your model, your unit may have beenpackaged with this kit. A complete drain kit containing allthe items needed to connect your unit is available fromyour dealer if your unit was not packaged with this. OrderPart No. U-CLRDRAINKIT.Note: Longer drain connections may require additionaldrain hose lengths. Additional drain line can be purchasedfrom your dealer or directly from McMaster-Carr.(McMaster-Carr # 52375K35)Follow these guidelines when installing drain lines toprevent water from flowing back into the ice makerstorage bin and/or potentially flowing onto the floor,causing water damage:Gravity DrainA Gravity Drain may be used if:• Drain line has at least a 1-inch drop per 48 inches ofrun (1/4 inch per foot).• Drain line does not create traps or created traps arevented (Figure 3).Figure 3See Figure 4 for a typical Gravity Drain installation.If using a Gravity Drain:1. Slide 2 hose clamps onto the drain connection on therear of the appliance.2. Insert the barbed fitting halfway into this connection.3. On the other end of this barbed fitting attach the 5/8”braided tubing.4. Slide a clamp on each side of the barbed fitting asshown (Figure 5).5. Insulate the drain line, if necessary to preventcondensation. Go on to Final Water/Drain ConnectionPage 8.Figure 4Figure 5NormalProper DrainWith TrapPoor Drainage, Water Will Back UpWith Trap and VentProper Drain ULIN_0569_AWasteWasteColdWaterShut-OffValveHotWaterGravity DrainULIN_0570_ADrain Fitting fromBack of UnitWorm ClampsDrain Line5/8" x 5/8"Barb ConnectorULIN_S_0166b2_A