U-Line CO1175 Use And Care Manual

Also see for ADA151M: Install guide Features and specifications

Contents

U-Line CO1175 Use And Care Manual Manual pdf 10 page image

11 U-Line Combo® Models and Ice Makers Maintenance124Removing and Installing Door ShelvesFor models equipped with door shelves:To remove the door shelf:1. Grasp shelf in center, and lift until the shelf notches (1) clearthe pins (2).2. Carefully pull the shelf away from the door.To install the door shelf:1. Holding the shelf in the center, center the shelf in the door atthe desired location, slightly above the pins (2).2. Lower the shelf onto the pins (2).12Removing and Installing GrilleWARNINGDisconnect electric power to the unit before removingthe grille.WARNINGDO NOT touch the condenser fins(4). The condenserfins are SHARP and can be easily damaged.Removing the grille.1. Disconnect power to the unit.2. Remove control knob (6) if equipped.3. Loosen the two screws (1). Some models may have only onescrew in the center.4. Remove grille (2) and grille cap (if equipped)(3) from unit.Installing the grille:1. For 15 and 29 models make sure grille cap (3) is behind grille inslots provided in grille before attaching grille to unit.2. For 75 models place the hook-hinge located on the rear bottomside of the grille (2) onto the front lip of the unit base. Swing thegrille up into position.3. Align cabinet and grill holes and secure, but do not overtightengrille screws (1).4. Install control knob (6) if equipped.5. Reconnect power to the unit.Ice Maker Models56 1223 1629 Models