U-Line CLR2160 Use And Care Manual

Also see for CLR2160: Service manual Installation instructions Installation instructions Supplementary guide Use and care guide

Contents

U-Line CLR2160 Use And Care Manual Manual pdf 14 page image

14 CLR2160, CLRCO2175Figure 124. Disconnect the hose connector (Figure 12, 1) from thewater solenoid valve (Figure 12, 2).5. DO NOT remove the inlet screen (Figure 12, 3) fromthe water solenoid valve. Use a toothbrush to gentlyclean any sediment from the inlet screen.6. Re-connect the water supply hose connector (Figure12, 1) to the water solenoid valve (Figure 12, 2).Tighten the connector securely.7. Open the water main supply valve and check for leaksat the water hose connection. Ensure that the watersupply line is not kinked.8. Reconnect power to the unit before re-installing.9. Make sure the drain system is working properly and thedrain hose is not pinched or kinked. Pour 1 gallon ofcool, fresh water into the ice bin. The water shoulddrain freely. If your unit is equipped with a drain pump,the pump should drain the ice bin.10. To ensure that the drain system is working properly,pour 1 gallon of cool, fresh water into the ice bin. Thewater should drain freely. If your unit is equipped witha drain pump, it should drain the ice bin.Ice Cube Thickness AdjustmentInterval - As RequiredIce thickness adjustments are made using the controlpanel as follows:Figure 131. To enter the thickness adjustment mode:a. Touch and hold the UP ARROW button (Figure13, 1).b. Touch and release the DOWN ARROW (Figure13, 2) button three times, then release the UPARROW button (Figure 13, 1).c. The display (Figure 13, 3) will switch to “0” toconfirm the thickness adjustment mode has beenselected.2. The factory setting is “0,” and the total range ofadjustment is -5 to +5. Use the UP ARROW button toraise the setting and thicken the ice bridge, or theDOWN ARROW button to lower the setting to thin theice bridge.IMPORTANTIMPORTANTIce thickness adjustment should only be made oneincrement at a time. Allow ice maker production tostabilize for 24 hours before rechecking icethickness.3. Touch and release the LIGHT (Figure 13, 4) button keyto exit the ice thickness adjustment mode.4. Remove all ice from the storage bin.Figure 145. Ice cubes in any given batch will vary, so it is necessaryto choose cubes from the sample area (Figure 14, 1)for comparison when making adjustments. If furtheradjustments are desired, repeat Steps 1 through 4.Drain PumpInterval - Not RequiredA drain pump, if installed, requires no routinemaintenance. To check its operation, pour 1 gallon ofcool, fresh water into the ice bin. The drain pump will runand water should drain freely from the bin.LevelingIMPORTANTIMPORTANTIt is extremely important that Clear Ice models arelevel. If not level, the ice mold will not fill evenly.3 21 ULIN_0061_A1 3 2ULIN_0200_A1ULIN_0063_A