U-Line CLR2160 Installation Manual

Also see for CLR2160: Service manual Installation instructions Installation instructions Supplementary guide Use and care guide

Contents

U-Line CLR2160 Installation Manual Manual pdf 7 page image

05/2007 7 www.U-LineService.comCLR2160/CLRCO2175 Ice MakersReversing the Door(Black and White Units Only)All U-Line units (exceptStainless Steel models) maybe left- or right-handopening. The door opening iseasily reversed by moving thehinge hardware to theopposite side. The top hingehardware will be used on thebottom of the other side andthe bottom hinge hardwarewill be used on the top of theother side (see Figure 7).To reverse the door:1. Remove top hinge screwpin from door (Phillipsscrewdriver) (see Figure8). Remove door by tiltingforward and lifting off bottom hinge pin.2. Remove plastic screw plugs (3 each, top and bottom)from new hinge location. Do not discard (see Figure 9).3. Remove top hinge (3 screws), reinstall hinge screw pin,and remount on opposite side BOTTOM (see Figure10).4. Remove the two door closer inserts from the existingbottom hinge and install as shown on the new bottomhinge (see Figure 11).5. Remove existing bottom hinge (3 screws) and remounton opposite side TOP. Remove hinge screw pin.6. Remove the plastic hole plug from the top of the doorto allow the pivot pin to be inserted in the newlocation. Install the plug into the vacated hole on theopposite side.7. With bottom of door facing up, remove pivot plate(2 screws), flip over, and remount on opposite side ofdoor (see Figure 12). Be sure notch in plate facescenter.8. Holding door upright with top of door tilted forward,place hole of door pivot plate on bottom hinge screwpin (see Figure 13).9. Tilt top of door intoposition in top hinge andinstall top hinge screw pin.10. Install plastic screw plugsremoved in Step 2 in oldhinge holes (3 each, topand bottom).ULIN_0015_AFigure 7Screw PlugsFigure 9ULIN_0133_AFigure 8DoorCloserInsertsFigure 1112ULIN_0003_AFigure 10Figure 12Figure 13