U-Line CLR2160 Installation Manual

Also see for CLR2160: Service manual Installation instructions Installation instructions Supplementary guide Use and care guide

Contents

U-Line CLR2160 Installation Manual Manual pdf 22 page image

www.U-LineService.com 22 05/2007CLR2160/CLRCO2175 Ice MakersRelocating the Shelves (CLRCO2175)Both the glass shelves in the refrigerator and the innerdoor shelves can be moved to accommodate your bottles,cans and containers.Glass Shelves on Right-Hand Hinge Units1. Open door fully, grasp shelf firmly, lift front edgeslightly and pull straight out.2. Choose new location and slide shelf onto theappropriate rib.Glass Shelves on Left-Hand Hinge Units1. See Figure 51. Pull shelfout about 6” to clear thewall’s molded protrusion.2. Tilt right-hand edge ofshelf up.3. Keeping at this angle andhugging the right wall,pull the shelf out.4. Choose new location andinsert over ribs, tiltingright-hand edge up. Pushin, then lower shelf ontoribs.Door Shelves1. First pull shelf up at a 45°angle, then straight out(see Figure 52).2. Choose new location andline up on bosses. Firstpush straight in, thendown at a 45° angle.Installation TroubleshootingProblemQ:Water is leaking under the unit.SolutionA:A water leak under the unit is most likely caused by a badconnection in the water supply line. Make sure the waterline’s brass fitting is screwed tight to its valve andthreaded correctly. Make sure the fill tube’s connection tothe water line is also tight. Check drain line to make sureit has not been disconnected from drain connection onback of the unit or disconnected from the drain.ProblemQ:The door remains open unless it is pushed closed.SolutionA:The hinges should be self-closing when the door is openapproximately 8 ". If this is not the case, make sure theclosers (at the bottom of the hinge pin) are clean, greasedand installed correctly. Also, re-check leveling from frontto back of the unit and readjust if necessary. Make surethat pivot plate is installed correctly.ProblemQ:The custom overlay door was designed to align with therest of the cabinet doors, but the unit has crept forward.SolutionA:First, make sure that the electrical cord and water supplyline are not obstructing the installation. If they are not,there is mostly likely not enough room allowed for thedrain connection on the rear of the unit. You may need toalter the wall behind the unit to accommodate the drainconnection.1. Pull Out 6"2. Tilt3. PullFigure 51BossNotchFigure 52

/ 24

Related manuals for U-Line CLR2160