U-Line ADA15IM Install Manual

Also see for ADA15IM: User guide Quick start guide Use and care guide Install guide Service manual

Contents

U-Line ADA15IM Install Manual Manual pdf 17 page image

Level & Install Unit 1612 InstallLeveling InformationADA15IM & BI2115It is recommended that the unit is level.1. Use a level to check thelevelness of the unit fromfront to back and from sideto side. Level should beplaced along top edge andside edge as shown2. If the unit is not level, adjustthe feet on the corners ofthe unit as necessary (notavailable in all models).3. Check the levelness after each adjustment and repeat theprevious steps until the unit is level.INSTALLATION TIPIf the room floor is higher than the floor in the cut-out opening,adjust the rear feet to achieve a total unit rear height of 1/8" lessthan the opening’s rear height. Shorten the unit height in the frontby adjusting the front feet. This allows the unit to be gently tippedinto the opening. Readjust the front feet to level the unit after it iscorrectly positioned in the opening.All Other ModelsIMPORTANTIMPORTANTIt is extremely important that these units sit on a levelsurface, as they do not have feet levelers. If they are notlevel, the ice mold will not fill evenly.Use a level to check thelevelness of the unit from frontto back and from side to side.Level should be placed alongtop edge and side edge asshown.1Turn Foot to AdjustInstallation1. Open the water supply valve in the main water source.2. Plug in the powercord.3. Gently push the unit into position. Be careful not to kink thewater supply line or entangle the electrical cord.4. Re-check the leveling, from front to back and side to side. Makeany necessary adjustments. The unit’s top surface should beapproximately 1/8" below the countertop.Grille InstallationBI95, BI98, WH95TP, BCM95BTP, BCM951. Locate and remove the grille screw from the cabinet, using astandard blade screwdriver (or a 1/4" nut driver).2. Identify the grille screw hole on the grille itself. It is locatedtoward the top of the middle recessed section of the grille.3. Place the two hook-hinges (located on the rear bottom side ofthe grille) onto the front lip of the unit base. Swing the grille upinto position, aligning the grille screw hole on the grille to thegrille screw hole on the cabinet. See Below.4. Insert the screw. Do not overtighten.SS1095 ModelsSS1095NF & SS1095FC models: Place the bottom lip of the grilleon the inside of the base pan and swing grille up into position.SS1095FD model: Align the tabs on the bottom of the grille withthe slots in the flange and swing grille up into position.Align the grille and cabinet screw holes.Insert the grille screw and tighten. Do not over-tighten1Grille ScrewHook-Hinge Unit BaseFront LipGrilleModel:SS109FDModels:SS1095NF & SS1095FCInsert This Lip Behind Base Plate LipAlign TabWith Slots

/ 19

Related manuals for U-Line ADA15IM