U-Line ADA15IM Install Manual

Also see for ADA15IM: User guide Quick start guide Use and care guide Install guide Service manual

Contents

U-Line ADA15IM Install Manual Manual pdf 12 page image

U-Line Door Reversal 11SS1095Reversing the DoorDepending upon the location of the unit, it may be desirable tochange the side on which the door is mounted.To reverse the door mounting, perform the following:1. Remove grille (one screw) (Figure 19).2. Remove top hinge from cabinet (three screws) (Figure 20).Hold door to keep it from falling.3. Lift the door off the bottom hinge.4. Remove bottom hinge from cabinet (two screws) (Figure 21).5. Remove screws on opposite side of cabinet (Figure 22).6. Install hinge on opposite side, bottom of cabinet (Figure 23).Align hinge outer edge with cabinet before tightening screws.7. Relocate plastic spacer/bushing (Figure 24) on top and bottomof door to opposite side. Clean out bushing hole in door bottomwith a screwdriver if necessary.8. Using a Phillips screwdriver, remove the two screws holding thecustom stainless handle from the original location, and removethe handle. Remove the two screws on the opposite side of thedoor (Figure 25). Do not place handle on door until you havecompleted, steps 9 & 10.9. Remove plastic hole plug (Figure 26) from door handle andrelocate on opposite side. Lift the handle slightly and press onthe locking tab, then gently pry the hole plug out of the holebeing careful not scratch the top cap.10. Relocate plastic spacer/bushing on top of door that wasunderneath the hinge to the opposite hole in top cap11. Attach handle removed in step 7 to opposite side of doorframe. Be sure to tighten all four screws removed in step 7.12. Remove pivot screw from top hinge, invert screw and reinstallpivot screw in top hinge (Figure 27).Mod elSS1095FCMod elSS1095FDGrillescrew19Hinge screws2021 222312425PlasticPlug HolePlasticPlug HoleHingeScrewRight SideDoor SwingRight SideHingeInvertScrewInvertHingeLeft SideDoor Swing26Press in locking tab, thenlightly pry up to remove holeplug and move to oppositeside27