U-Line ADA151M Install Manual

Also see for ADA151M: Use and care guide Features and specifications

Contents

U-Line ADA151M Install Manual Manual pdf 15 page image

U-Line Other Requirements 149Electrical SpecificationsWARNINGSHOCK HAZARD — Electrical Grounding Required.• Never remove the round grounding prong from theplug and never use a two-prong grounding adapter.• Never use an extension cord to connect power to theunit.IMPORTANTIMPORTANTElectrical installation must observe all state and localcodes. This unit requires connection to a grounded (three-prong), polarized receptacle that has been placed by aqualified electrician.The unit requires a grounded and polarized 115 VAC, 60 Hz, 15Apower supply (normal household current). An individual, properlygrounded branch circuit or circuit breaker is recommended. GFCI(ground fault circuit interrupter) is usually not required for fixedlocation appliances and is not recommended for your unit becausea GFCI could be prone to nuisance tripping. However, be sure toconsult your local codes.10 Power SupplyChecking Door AlignmentThe unit’s door is aligned at the factory before shipment. However,its alignment could have been disturbed during shipment.IMPORTANTIMPORTANTProperly aligned, the door’s gasket should be firmly incontact with the cabinet all the way around the door (nogaps).1. Carefully examine the door’s gasket to assure that it is firmly incontact with the cabinet.2. When inspecting door alignment, make sure the door gasket isnot pinched on the hinge side of the door.Adjusting Door AlignmentBI-21151. Remove top hinge screw pin Remove door by tilting forwardand lifting off bottom hinge pin.2. With door upside-down, loosen but do not remove the twoscrews on the door’s bottom hinge plate.3. If the top far edge of the doorneeds to move UP, move thehinge plate toward the outsideof the door and retightenscrews. If the top far edge ofthe door needs to moveDOWN, move the hinge platetoward the inside of the doorand retighten screws.4. Mount the door to recheckalignment and repeat Steps 2and 3 if further adjustment isnecessary.5. When top edge of door isparallel to top edge of cabinet,remove the door and ensurethe two screws are secure.6. Remove the door closersfrom the bottom hinge, cleanthoroughly and lubricate the mating surfaces with petroleumjelly.7. Reinstall the closers, lining up the bosses with holes in hinge andhinge plate.8. Mount the door, install top hinge pivot pinAll Other Models1. Loosen (do not remove) top and bottom hinge screws.2. Align door squarely with cabinet. Make sure gasket is firmly incontact with cabinet all the way around the door (no gaps).3. Tighten bottom hinge screws.4. Tighten top hinge screws.9 Adjust DoorDoorCloserInsertsBossNotch(must face towardcenter of door)SlottedMountingHolesRaiseOutsideDoor EdgeLowerOutsideDoor Edge23-1/8"1-1/2"7"ADA15IMBI95, WH95TP, BI95BTP & BCM9518-1/2"Minimum1-1/2"7"21-1/2"Minimum4"7"BI98SS-1095(NF)(FC)(FD)BI21151-1/2"7"26-5/16" MinimumSP18AcceptableLocationPreferredLocationfor Receptacle1-1/2"7"24"1"7"