U-Line 2115R Use And Care Manual

Also see for 2175R: Service manual Supplementary guide Features & benefits Use and care guide Installation guide

Contents

U-Line 2115R Use And Care Manual Manual pdf 17 page image

2115R, 2175R 17Troubleshooting GuideDANGERELECTROCUTION HAZARDNever attempt to repair or perform maintenance onthe unit until the main electrical power has beendisconnected.NOTE: Recommended temperature setting is 38°F.Troubleshooting - What to check when problems occur:PROBLEM POSSIBLE CAUSE REMEDYUnit does not operate andelectronic display is blank.No electrical supply Plug unit in or check circuit breaker.No interior light Loose or burned out bulb Tighten or replace bulb (See MAINTENANCE; LIGHTBULB REPLACEMENT).Electronic display is blank andinterior light is OFF with door OPEN.Unit is in blackout/Sabbath mode(not Star K certified) lighting mode.Exit blackout/Sabbath mode (not Star K certified)(See OPERATION; INTERIOR LIGHT CONTROL).Electronic display is blank andinterior light is ON with door OPEN.A display function has changed. Touch and hold the warmer temperature button andtouch and release the POWER button three times, thenrelease the temperature button. The display shouldbecome visible.Electronic display shows repeating,randomly flashing symbols andpartial characters.A factory control mode has beeninadvertently entered.Touch and hold the warmer temperature button andtouch and release the LIGHT button three times, thenrelease the temperature button to exit the factorycontrol mode. The set-point temperature should nowbe displayed.Electronic display shows:0, 1 to 26, or 99.A factory control mode has beeninadvertently entered.Repeatedly touch the warmer temperature button toadvance any number shown to 99 and touch andrelease the LIGHT button. The set-point temperatureshould now be displayed.Electronic display shows E3. Door has been left open longer than20 minutes.Close door completely. The set-point temperatureshould now be displayed.Electronic display shows one ormore of the following:E1, E2, E4, E5, E6, E7, E8, E9, E10, P1.The unit is displaying an error code. Record the error code(s) displayed and call for service.Unit not cold enough. Checktemperatures (See OPERATION forapproximate temperatures).Control set too warm Set control to a cooler setting (See OPERATION). Allow24 hours for temperature to stabilize.Airflow to front grille blocked Airflow must not be obstructed to front grille (SeeOPERATION).Dirty condenser coils Clean condenser (See MAINTENANCE; CONDENSERCLEANING).Door gasket not sealing properly Door adjustment required (See MAINTENANCE; DOORALIGNMENT CHECK AND ADJUSTMENT).Inaccurate temperature reading Properly check temperature (See OPERATION).Unit is too cold. Check temperatures(See OPERATION for approximatetemperatures)Control set too cold Set control to a warmer setting (See OPERATION). Allow24 hours for temperature to stabilize.The unit frosts up. High ambient temperatures orhumidityDefrost unit manually (See MAINTENANCE;DEFROSTING).Door gasket not sealing properly Adjust door (See MAINTENANCE; DOOR ALIGNMENTCHECK AND ADJUSTMENT and DOOR REVERSAL).Item(s) interfering with door Reposition or remove item(s).Noise during operation Copper water supply tubingcontacting internal componentsCarefully bend tubing away from cabinet andcomponents.Refrigerator too cold Temperature control set too cold Set control to warmer setting (See OPERATION).Inaccurate temperature reading Properly check temperature (See OPERATION).

/ 20

Related manuals for U-Line 2175R