| 
e-STUDIO163/203 ADJUSTMENT December 2005 © TOSHIBA TEC3 - 8(6) After the adjustment for the code 411 is completed, apply the same adjustment value for thecode 410.(Adjustment Mode) Æ (Key in the code [410]) Æ [START]Æ (Key in the same value in the step 5 above)Æ Press [ENTER] or [INTERRUPT] (Stored in memory).Note:Note:Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.[C] Reproduction ratio of secondary scanning direction (Fine adjustment of main motor rota-tion speed (Copier/Printer))(1) While pressing [0] and [5] simultaneously, turn the power ON. Æ (Adjustment mode)(2) Press [1] Æ [INTERRUPT]. (A grid pattern with 10 mm squares is printed out. Use A3/LD fromstandard drawer of the equipment.(3) Check the grid pattern on the test chart printed out and measure the distance C from the 10thline at the leading edge of the paper to the 30th line of the grid pattern.* Normally, the 1st line of the grid pattern is not printed.(4) Check if the distance C is within 200±0.5 mm.(5) If not, use the following procedure to change values and measure the distance C again.(Adjustment Mode) Æ (Key in code [421]) Æ [START]Æ (Key in a value (acceptable values: 0 to 255))Æ [ENTER] or [INTERRUPT] (Stored in memory)Æ “100% A” is displayedÆ Press [1] Æ [INTERRUPT] Æ (A grid pattern is printed out.)* The larger the adjustment value is, the longer the distance C becomes (approx. 0.125 mm/step). |
