E65816112I Limits in purposeThis inverter is used for controlling speeds of three-phase induction motors in general industrial use.Single-phase input model is output by the inverter as three-phase output and cannot drive a single-phase motor.Safety precautionsThis product is intended for general purpose uses in industrial application. It cannot be usedapplications where may cause big impact on public uses, such as power plant and railway, andequipment which endanger human life or injury, such as nuclear power control, aviation, space flightcontrol, traffic, safety device, amusement, or medical.It may be considerable whether to apply, under the special condition or an application where strictquality control may not be required. Please contact your Toshiba distributor.Please use our product in applications where do not cause serious accidents or damages even ifproduct is failure, or please use in environment where safety equipment is applicable or a backup circuitdevice is provided outside the system.Please do not use our product for any load other than three-phase induction motors in generalindustrial use. (Use in other than properly applied three-phase induction motors may cause anaccident.)Single-phase input model is output by the inverter as three-phase output and cannot drive a single-phase motor. HandlingWarning ReferencesectionDisassemblyprohibited Never disassemble, modify or repair.This can result in electric shock, fire and injury. Call your Toshiba distributor for repairs.2.Prohibited Never remove the terminal block cover when power is on.The unit contains many high voltage parts and contact with them will result in electric shock. Do not stick your fingers into openings such as cable wiring holes and cooling fan covers.This can result in electric shock or other injury. Do not place or insert any kind of object (electrical wire cuttings, rods, wires etc.) into theinverter.This can result in electric shock or fire. Do not allow water or any other fluid to come in contact with the inverter.This can result in electric shock or fire.2.12.2.2.Mandatoryaction Turn the power on only after attaching the terminal block cover.If the power is turned on without the terminal block cover attached, this can result inelectric shock or other injury. If the inverter begins to emit smoke or an unusual odor, or unusual sounds, immediatelyturn the power off.Continuous use of the inverter in such a state will cause fire. Call your Toshiba distributorfor repairs. Always turn the power off if the inverter is not used for long periods of time since there is apossibility of malfunction caused by leaks, dust and other material. If power is left on withthe inverter in that state, it can result in fire.2.13.3.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
