Toshiba TOSVERT VF Series Manual

Also see for TOSVERT VF Series: Instruction manual

Ｅ６５８２０５６72.2. In case of other than Toshiba standard IE3 motors (4pole)For adaptation other than Toshiba standard IE3 motors (4pole), the motor parameters setting are required.Please set them refer to motor name plate or test report.Even if you use Toshiba standard IE3 motors (4-pole), If the base frequency is set to other than 200V or 400V, the motorparameters setting are required.2.2.1. Setting of V/F parametersSet the Base frequency1 and the Base frequency voltage1.Title CommunicationNo. Functionvl 0014 Base frequency 1vlv 0409 Base frequency voltage 1- In case of pt=0,1(Common), only set the Torque boost value1(vb).Regarding vb, please adjust refer to the values in Table 1.1 and Table1.2.- In case of pt=5(VF-AS1/VF-PS1), 7(VF-S15), set the parameters f190～f199 for V/F 5-point setting and setvb.Regarding vb, please adjust refer to the values in Table 1.1 and Table1.2.- In case of pt=2,3(Common), 4(Except for VF-PS1), 5(VF-S15), 7(VF-AS1/VF-PS1), 8(VF-AS1), 9, 10(VF-PS1),proceed to 2.2.2 section.2.2.2. Perform the Auto-tuningIn case of the following V/F control mode selection (pt), Auto-tuning is required.Please perform the Auto-tuning according to the next page procedure.VF-AS1Automatic torque boost (pt=2), Sensorless vector control1 (pt=3), Sensorless vector control2 (pt=4),PG feedback control (pt=7), PG feedback vector control (pt=8)VF-PS1Automatic torque boost (pt=2), Sensorless vector control1 (pt=3), PG feedback control (pt=7),Energy-saving (pt=9), Advanced energy-saving (pt=10)VF-S15Automatic torque boost control (pt=2), Vector control (pt=3), Energy-saving (pt=4),Dynamic energy-saving (pt=5)