Toshiba TOSVERT VF-MB1 Function Manual

Also see for TOSVERT VF-S15 series: Function manual Quick start manual Instruction manual Instruction manual Instruction manual

E6581738④- 24 -7. Vendor Spec. ProfileCyclic command transmission (the value of the parameter c001 - c006) andmonitoring (the value of the parameter c021 - c026) are possible for PDP003Z bythe original profileSelect the ”Telegram 100”, ”Telegram 101” or ”Telegram 102” as the profile on theconfiguration. Refer to the PLC configurator documents.VF-MB1/S15 profileScanner input c001 - c006 Scanner output c021 - c0260: No action1: fa06 (Communication command 1)2: fa23 (Communication command 2)3: fa07 (Frequency command, 0.01Hz)5: fa50 (Terminal output data)6: fa51 (FM analog output)8: f601 (Stall prevention level, %)13: acc (Acceleration time 1, 0.1s)*14: dec (Deceleration time 1, 0.1s) *15: ul (Upper limit,0.01Hz)16: vb (Torque boost value 1,0.1%)17: vlv (Base frequency voltage 1, 0.1V)0: No action1: fd01 (Status information 1)2: fd00 (Output frequency, 0.01Hz)3: fd03 (Output current, 0.01%, With filter)4: fd05 (Output voltage, 0.01%, With filter)5: fc91 (Alarm information)6: fd22 (PID feedback value, 0.01Hz)7: fd06 (Input terminal board status)8: fd07 (Output terminal status)9: fe36 (VIB input, 0.01%)10: fe35 (VIA input, 0.01%)11: fe37 (VIC input, 0.01%)12: fd04 (Input voltage (DC detection), 0.01%, Withfilter)13: fd16 (Estimated speed (real-time value), 0.01Hz)14: fd18 (Torque, 0.01%, With filter)19: f880 (Free notes)20: fd29 (Input power, 0.01kW, With filter)21: fd30 (Output power, 0.01kW, With filter)22: fe14 (Cumulative operation time, hour)23: fe40 (FM terminal output monitor, 0.01%)25: fd20 (Torque current, 0.01%, With filter)26: fd23 (Motor overload factor, 0.01%)27: fd24 (Drive overload factor, 0.01%)28: fd25 (PBR overload factor, %)29: fd26 (Motor load factor, %)30: fd27 (Drive load factor, %)31: fe56 (Pulse train input, pps)32: fe70 (Drive rated current, 0.1A)33: fe76 (Input Watt-hour, 0.1kWh  10f749) **34: fe77 (Output Watt-hour, 0.1kWh  10f749) **35: fd83 (IGBT temperature, degree C)* The unit of acc, dec is according to the parameter f519.** The unit of fe76, fe77 is according to the parameter f749.*** The value which is transferred by the cyclic command transmission will not be stored to EEPROM.