9EGSTEP 3 Set the ON time and OFF time, and press the SETbutton.• Set the trigger time with the HH and MM buttons, andpress the SET button.• When the SET button is pressed, the ON timechanges from blinking to lighting and, at the sametime, the OFF time starts blinking.STEP 4 Set up programs in the same way.• When the SET button is pressed, settings areautomatically arranged in the order of earliest timefirst.• If the SET button is pressed without any new settingsbeing made in the program, program startsblinking again and settings can be changed.• Similarly, if the SET button is pressed with the thirdprogram set up, the first program starts blinking.STEP 5 Press the PROGRAM button.• Program settings are entered and the normal displayreturns.STEP 6 Set up programmed operation for other days of the week in the same way.Programs that have already been set up can be copied into other days of the week. (Refer to page 13)NOTE• A “0:00” time setting is interpreted to mean 12:00 midnight.• To cancel program settings during program setup (while “PG-1” or “PG-2”is blinking on thedisplay), hold down the CANCEL button for more than 2 seconds. The normal displayreturns.• If settings are canceled without pressing the PROGRAM button, settings are not entered.OI-916-9-EG916_TCB-EXS21TLE_Book1.book 9 ページ 2007年8月21日 火曜日 午後3時20分