FeaturesCall ForwardStrata DK Standard Telephone 5/99 11ä To cancel Call Forward-Externalä Lift the handset and press.Remote Call Forward—External Destination ChangeIf Call Forward-External mode is set at your station, you can change the forwardingdestination from a telephone outside of the system.The destination is normally an external Public Telephone Network Number, but it can alsobe an internal Directory Number.ä To change the destination numberExample: 8015833700801 = CO Line access code5833700 = Telephone numberImportant! See Table 1 on Page 38 for CO Line/LineGroup access codes. The LCR access code “9” cannot beused.2. Lift the handset andpress.3. Hang up. Incoming calls will forward to the destination stored atStation Speed Dial Location 49.1. Call into the StrataDK system over a COline programmed forthe DISA feature.You hear ring back tone signal, then internal dial tone for10 seconds. Try again if you hear busy tone.Note See the System Administrator for DISA telephonenumbers.2. After you hear dialtone, press,then enter a [PDN].You hear a confirmation tone.If a number is not dialed, the system automatically causesthe DISA CO line to ring at telephones as a normalincoming call. Then, if the call is not answered within 15seconds after the ringing starts, it disconnects.