4-20 User’s ManualOperating BasicsPulling the drawer open3. Place the disc, label side up, in the drawer.Inserting a disc4. Press gently at the centre of the disc until you feel it click into place. Thedisc should lie below the top of the spindle, aligned with the spindlebase.5. Push the center of the drawer to close it. Press gently until it locks intoplace.TOSHIBASatelliteWhen the drawer is fully opened, the edge of the computer will extendslightly over the disc tray. Therefore, you will need to turn the disc at anangle when you place it in the tray. Once the disc is seated, make sure itlies flat, as shown in the figure above.■ Do not touch the laser lens. Doing so could cause misalignment.■ Keep foreign matter from entering the drive. Before closing the drive,check the back edge of the tray to make sure it carries no debris.If the disc is not seated properly when the drawer is closed, the disc mightbe damaged. Also, the drawer might not open fully when you press theeject button.