Toshiba E-studio2555c Troubleshooting Manual

Also see for e-studio 2555c: Safety information Copying guide Troubleshooting guide Service manual

Contents

1 TROUBLESHOOTING FOR THE HARDWARE70 When Printed Sheets Overflow from the Exit TrayWhen Printed Sheets Overflow from the Exit TrayWhen thin, small size paper (A4-R/LT-R or smaller) is used, the end of the sheets may get stuck in the exit tray walls. If300 or more sheets are printed under such condition, some printed sheets may be pushed out of the exit tray.In the case above, installing the paper exit stopper at the designated location of the exit tray will increase the amount ofrecommended plain paper that can be loaded on to the exit tray to about 500 sheets. When printing a large number of large size sheets such as A3 and A4/LD and LG, place the paper exit stopper backin its original location. When the finisher or inner tray is installed in the equipment, use the paper exit stopper installed in its originallocation.Removing the paper exit stopper from its original locationInstalling the paper exit stopper in the designated location for improving paper exitPlacing the paper exit stopper back in its original location1 Remove the paper exit stopper from the groove on the exit tray while pushing itsfulcrum inward.1 Unfold the paper exit stopper located on the left of theexit tray and remove it from its groove while pushingthe fulcrum inward.1 Turn the tip of the paper exit stopper to the left andinsert the paper exit stopper fulcrum into the grooveon the exit tray.2 Install the paper exit stopper in the groove on the leftof the exit tray.